[네트워크] cisco route setup 하기..

setup command를 이용한 설정(대화형식의 라우터 설정)

예) Router#setup

— System Configuration Dialog —

At any point you may enter a question mark ””?”” for help.

Use ctrl-c to abort configuration dialog at any prompt.

Default settings are in square brackets ””[]””.

Continue with configuration dialog? [yes]: —— 대화형식의 환경설

정

First, would you like to see the current interface summary? [yes]:

Interface IP-Address OK? Method Status Protocol

Ethernet0 203.255.112.228 YES NVRAM up up

Serial0 203.231.85.138 YES manual down down

Configuring global parameters:

Enter host name [Router]: router —— 라우터의 명칭

The enable secret is a one-way cryptographic secret used

instead of the enable password when it exists.

Enter enable secrect : router – enable password(암호화된 형태)

enable password 보다 우선

The enable password is used when there is no enable secret

and when using older software and some boot images.

Enter enable password [router]: router —— enable password(일반

text 형태)

Enter virtual terminal password [router]: router —— 외부에서 접속

할 때 묻는 password

Configure SNMP Network Management? [yes]: —— NMS를 정의

Community string [public]: —— SNMP community 설정

Configure IP? [yes]: —— ip address 설정

Configure IGRP routing? [no]:—— IGRP 프로토콜 사용 안함

Configure RIP routing? [yes]: —— RIP 프로토콜 사용

Configuring interface parameters:

Configuring interface Ethernet0:

Is this interface in use? [yes]: —— ethnet 인터페이스 사용

Configure IP on this interface? [yes]: —— ip address 설정함

IP address for this interface [203.255.112.228]: —— 사용할 ip

address 기입

Number of bits in subnet field [0]: —— subnet 비트 수(0은 디폴

트)

Class C network is 203.255.112.0, 0 subnet bits; mask is /24

Configuring interface Serial0:

Is this interface in use? [yes]: —— serial 인터페이스 사용

Configure IP on this interface? [yes]: —— ip address 설정함

Configure IP unnumbered on this interface? [no]: —— ip address 설

정함

IP address for this interface [203.231.85.138]: —— 사용 할 ip

address 기입

Number of bits in subnet field [6]: —— 6비트로 subnet

Class C network is 203.231.85.0, 6 subnet bits; mask is /30

The following configuration command script was created:

hostname router

enable secret 5 $1$msJM$TvuEk.ljvlRD98LBHb5ya/

enable password router

line vty 0 4

password router!

ip routing

!

interface Ethernet0

ip address 203.255.112.228 255.255.255.0

!

interface Serial0

ip address 203.231.85.138 255.255.255.252

!

router rip

network 203.255.112.0

network 203.231.85.0

!

end

Use this configuration? [yes/no]: y —— 환경 설정 사용함

The enable secret you have chosen is the same as your enable

password.

This is not recommended. Re-enter the enable secret.

The enable password you have chosen is the same as your enable

secret.

This is not recommended. Re-enter the enable password.

Building configuration… [OK]

Use the enabled mode ””configure”” command to modify this

configuration.

router#